How to Use

Surface Preparation: 

• Ensure the surface is clean, dry, dust-free and grease-free before application.
• Remove any existing efflorescence, dirt or residues with appropriate cleaners (e.g., efflorescence remover, fungus and mold remover or a hard surface limescale cleaner).
• Allow the surface to dry completely before treatment.

Application Steps

• Shake the product container well before use.
• For most applications, dilute Winseal Premium Clear Protective Coating with up to 30% potable water. Mix it well to achieve a homogenous or uniform consistency.
• Apply Winseal premium clear glossy sealer evenly using a brush, roller, or low-pressure sprayer.
• Work in manageable sections to avoid overlaps and ensure uniform sheen. Apply an even, continuous coat without excessive rolling pressure in one direction. 
• Immediately after application while the coating is wet, use a clean, dry, lint-free roller (for de-aeration) to lightly pass over the freshly applied coating. 
• Roll in one direction only, using very light pressure.
• Roll in one direction only, using very light pressure.
• This step allows entrapped air bubbles or foam to break naturally and helps the coating settle evenly on the surface.
• Do not reload the second roller with material.
• Wipe off excess material from the surface while the coating on the surface is wet using the second roller. 
• Allow the coating to dry for a period of 3 to 4 hours.
• Apply a second light coat in a perpendicular direction. While application, 
• Allow the surface to dry and cure fully for 48 hours before use. 

Pro Tip: 

• Always use two separate rollers: one for application, one exclusively for de-aeration.
• Avoid high-speed rolling or excessive back-and-forth movements.
• Do not apply in very hot, windy or highly humid conditions.
• Conduct a small trial application to familiarise with surface behaviour.

Application Details

Coverage: 

Low Porosity: Kadappa, Granite - 7 to 12 m2 per Ltr in 2 coats

High Porosity: Brick, Concrete - 4 to 7 m2 per Ltr in 2 coats

(Actual coverage depends on substrate porosity and surface texture.)

Recommended Application Tools

• Soft bristle paint brush – edges and tight areas
• Short nap roller/Mohair roller – flat surfaces
• Low-pressure sprayer – even wetting
• Lint-free cloth – remove excess where necessary

Important Tips:

• Apply in temperatures between ~10–35°C
• Avoid application in direct rain or extremely humid conditions until cured
• Do not over-apply — a uniform thin film achieves the best look